I’m blocked debugging a watchOS app on a physical Apple Watch. The iPhone connects to Xcode normally (wired), but the Watch either fails to connect with a tunnel timeout or disappears entirely from Xcode after I unpaired it inside Devices & Simulators. Environment Mac: macOS 26.x (Apple Silicon Mac) Xcode: 26.2 iPhone: iOS 26.1 Apple Watch Ultra: watchOS 26.2 (build 23S303) Connection: iPhone connected to Mac via USB (trusted). Watch paired to iPhone and working normally in the Watch app. Issue A (when Watch is visible in Xcode) In Xcode → Window → Devices and Simulators, the Watch shows up but is not usable and fails to connect. Error: “Previous preparation error: A connection to this device could not be established.” “Timed out while attempting to establish tunnel using negotiated network parameters.” In some attempts the Watch shows “Capacity: Unknown” / limited details, and then fails during preparation. Issue B (after unpairing Watch in Xcode only) I unpaired/removed the Watch in Xcode (Devices & Simulators). I did not unpair the Watch from the iPhone. Now: iPhone appears in Xcode and works normally for builds. Watch is still paired to the iPhone and works normally. Watch no longer appears anywhere in Xcode Devices & Simulators (no paired watch section, no watch run destination). What I’ve tried Reboots of Mac, iPhone, Watch (multiple times) Watch unlocked, awake; iPhone unlocked and close to Watch Verified Watch is paired and connected in iPhone Watch app Developer Mode enabled on iPhone and Watch Wi-Fi and Bluetooth ON (Mac/iPhone/Watch), tried toggling both Tried on home Wi-Fi and also with iPhone hotspot (same result) Resetting trust prompts / reconnecting iPhone via USB, re-trusting Mac Apple Watch: “Clear Trusted Computers” Xcode: removing/re-adding devices; clearing derived data; restarting Xcode Watch Developer networking test: Responsiveness = Medium (430 RPM) Questions 1. Is this a known issue/regression with Xcode 26.2 + watchOS 26.2 tunneling (CoreDevice / devicectl)? 2. Is there an Apple-supported way to force Xcode to re-discover a paired Watch after it was removed from Xcode Devices & Simulators (without unpairing the Watch from the iPhone)? 3. Any recommended logs or diagnostic steps I should collect (Console logs, sysdiagnose, specific Xcode/CoreDevice logs) to include in a Feedback report? If helpful, I can provide the full error text from Xcode’s Devices window and any logs you recommend. Thank you in advance,