I am implementing a custom generic spatial accessory according to Section 20 of the Accessory Design Guidelines dated 2026-06-08. Apple Vision Pro discovers the accessory, completes BLE pairing and encryption, reads the Apple Spatial Accessory Version and Uniform Type Identifiers characteristics, and recognizes the device in the accessory tracking debug view. However, visionOS writes ASA protocol version 00.00 to the Apple Spatial Accessory Host Version characteristic instead of selecting version 01.01.
Here is the log message when I connected my spatial accessory with apple vision pro with os27 beta 3. The error is the ASA part.
BLE advertising: ZemScannerASA15; BLE ATT MTU tx=23,rx=23; BLE conn timing connected: interval=30000; us,latency=0,timeout=72; TimeSync anchor report enabled: h=0x011f; BLE connected TimeSync anchor #1 ce=0,int=30000,delay=0 TimeSync anchor #2 ce=3,int=30000,delay=0 TimeSync anchor #3 ce=4,int=30000,delay=0 BLE ATT MTU tx=293,rx=65 BLE security level 2 BLE pairing complete, bonded ASA version read #1 off=0 req=64 hex=02 01 01 01 01 ASA UTI read #2 off=0 req=64 total=49 ASA host wr #3 o=0 l=4 f=00 hex=00 00 01 31 ASA host raw: off=0,write=4,total=4,hex=00 00 01 31 ASA host version: >len=4,ver=0.0,features_len=1,features=0x31 ASA host selected no common protocol HID direct input report sent HID notif #4 report=3 enabled HID IMU stream started HID notif #5 report=2 enabled HID IMU report sent BLE conn params updated: interval=7500 us,latency=4,timeout=100
