Hi, @indeedshaw, Did you solve this problem? Could you share the solution?

Dear Apple： Can you help me？

Dear Apple： Our operation steps are as follows: 1、 pair the Apple phone with the Garmin watch via Bluetooth. 2、When another app is in the foreground, use BLE Bluetooth to send a custom broadcast. However, since the data is quite large and cannot fit entirely in the broadcast, the remaining data is sent in the BLE Scan Response. The other device starts BLE scanning. 3、our BLE packet capture shows that the Apple phone does not send the BLE Scan Response. Currently, we have found that only the iPhone XS Max has this issue; it is still unknown whether other iPhone models have the same problem.

bug number：17540931

Additionally, do the Bluetooth and Wi-Fi on the iPhone use the same RF transmitter? Are they time-division multiplexed?

Hi Could anyone give a confirmation on my comment？ In my case , i would read a nfc tag and launch an clip card on my local device, do you mean there is no way now to test the experience from clip card "OPEN" button to full app? For that , I must upload and publish my app to App Store within App Clip? Is there any possibility to test this whole experience through testflight ? Great thanks!

Dear apple： We have found that the probability of connection failure when attempting to connect to WiFi on an iPhone after the screen has been off for a while is relatively high, and the failure rate is even higher when the WiFi channel is on 2.4G. Is this a known issue with Apple WiFi connections?Thank you

Dear Apple: I'm doing this: 1、Run your app on the iPhone. 2、Still using iPhone Mirroring, invoke the UI in your app that 3、causes it to call NEHotspotConfigurationManager.

dear apple： We tried to connect to the Wi-Fi in the settings interface and attempted it 100 times without any connection failures. What should we do next for troubleshooting?

i find another problem。after wifi connect success，i need wait for almost 3 seconds to get the ip and mask, is this OK?